Modular Modem 336MM-T-WS / 560MM-T-WS

336/560MM-T-WS, International DAA, 3.3V& 5V Operational Modular Modems™

The 336MM-T-WS and 560MM-T-WS are fully self-contained modem modules with on board data pump and modem controller. The module provides system designers the flexibility to include modem functionality in any system product, with minimal engineering resources. The modem module comes with an International DAA and firmware capable of supporting more than thirty major country telecom standards. The modems are FCC68 and CS-03 certified, designed to meet UL/CSA and TUV, CB Scheme requirements.

Features:

-40^oC TO +85^oC extended operating temperature
2.165" W x 2.500" L x 0.350" H (0.20" optional)
Single RJ -11 phone jack (optional) - 0.60"H
Serial TTL interface
V.90, 56 kbps data (560MM-T-WS)
V.34, 33.6 kbps data (336MM-T-WS)
14.4 kbps fax, Group 3, Class I & II
Voice playback and record
DTMF decode
V.42, MNP2-4 and 10 error correction
V.42bis and MNP-5 data compression
Automatic voltage detection for 5V and 3.3V systems
Low power consumption
Caller ID
Designed to meet global telecom compliance

336/560MM-T-WS

336/560MM-T-WS-J

Countries supported by existing firmware:
Australia, Austria, Belgium, Brazil, Canada, China, Denmark, Finland, France, Germany, Greece, India, Ireland, Italy, Japan, Korea, Malaysia, Mexico, Netherlands, Norway, Poland, Portugal, Singapore, South Africa, Spain, Sweden, Switzerland, Taiwan, UK, US and TBR21 Generic.

Note:

More country codes are available, please contact Radicom for information.
More country Telecom Agencies such as Iceland, Luxembourg, Israel may adopt the TBR21 standards. The existing firmware could then be used to support those countries.

Ratings @ 25^o C

Parameter

Min

Typ

Max

Units

Tip / Ring Current Continuous

120

Dielectric Withstanding Voltage

1650

VRMS

Operating Temperature

-40

+85

^oC

Relative Humidity (non-condensing)

^o/_o

_{Voltage Requirement}

3.15

_5.25

_VDC

_{Power Consumption}

346

871

_mW

_Current

110

139

166

_ma

_{Transmit & Receive Level}

_-10

-20

_-43

_dBm

(updated 4/9/2002)

Mechanical Diagram & Pin Assignments - Serial Interface
Note: Header extends on non-component side. Can be reversed if necessary. (contact factory) Header length is 0.236" on non-component side. Pin spacing is 0.100" from center to center. Tip and ring trace clearance must exceed 0.100" metal to metal. 0.350" H on component side (0.20" optional) Single RJ -11 phone jack on component side (optional) - 0.60"H

Information furnished by Radicom Research is believed to be accurate and reliable. However Radicom Research assumes no responsibility for its use, or any infringement of patents or other rights of third parties which may result from its use. Radicom Research reserves the right to change circuitry at any time without notice. This document is subject to change without notice.

The information contained herein is subject to change without notice. Logos, trademarks and copyrights are property of their respective owners.