336/560MM-P-WS, Worldwide Telecom Compliant, Parallel Interface Modular Modems™ The 336/560MM-P-WS family is a self-contained module that provides system designers the flexibility to include modem functionality in any system product, with minimal engineering resources. The 336/560MM-P-WS family is built with on-board International DAA. Its firmware supports more than 30 major country's telecom requirements worldwide. The modem features caller ID, high-speed data rates up to 56 kbps, operational under 5V or 3.3VDC.
Features: Parallel interface V.90, 56 kbps data (560MM-P-WS) V.34, 33.6 kbps data (336MM-P-WS) 14.4 kbps fax Voice playback and record DTMF decode 2.160" x 2.500" x 0.350" V.42, MNP 2-4 and 10 error correction V.42bis, and MNP-5 data compression 5V or 3.3V operational FCC Part 68 registered Designed to meet UC/CSA and TUV requirements Worldwide telecom compliance * Caller ID
* Countries supported by existing firmware: Australia, Austria, Belgium, Brazil, Canada, China, Denmark, Finland, France, Germany, Greece, India, Ireland, Italy, Japan, Korea, Malaysia, Mexico, Netherlands, Norway, Poland, Portugal, Singapore, South Africa, Spain, Sweden, Switzerland, Taiwan, UK, US and TBR21 Generic. Note: More country codes are available, please contact Radicom for information. More country Telecom Agencies such as Iceland, Luxembourg, Israel may adopt the TBR21 standards. The existing firmware could then be used to support those countries. Ratings @ 25o C Parameter Min Max Units Tip / Ring Current Continuous 10 120 mA Dielectric Withstanding Voltage - 1650 VRMS Operating Temperature 0 +70 oC Relative Humidity (non-condensing) 10 95 o/o Voltage Requirement (5V typical) 4.75 5.25 VDC   Power Consumption 640 740 mW Voltage Requirement (3.3V typical) 3.15 3.45 VDC   Power Consumption 390 500 mW Transmit & Receive Level -10 -43 dBm Mechanical Diagram & Pin Assignments - Parallel Interface Note: Header extends on non-component side. Can be reversed if necessary. (contact factory) Header length is 0.236" on non-component side. Pin spacing is 0.100" from center to center. Tip and ring clearance must exceed 0.100" metal to metal. Pin size is 0.025" x 0.025" square Information furnished by Radicom Research is believed to be accurate and reliable.  However Radicom Research assumes no responsibility for its use, or any infringement of patents or other rights of third parties which may result from its use.  Radicom Research reserves the right to change circuitry at any time without notice.  This document is subject to change without notice. The information contained herein is subject to change without notice. Logos, trademarks and copyrights are property of their respective owners.

[ Home ][ Company ][ Products ][ Contact Us ][ Career ][ Patents ]