SlimModem2
|
|
|
|
|
Available: |
 |
Pin-to-pin Compatible with Conexant SocketModem |
|
-40°C to +85°C Operating Temperature |
|
36.6K / 56K bps Data, Fax, Voice Play back and Recording |
|
RoHS Compliant |
|
3KVAC Dielectric Breakdown (on selected model) |
|
Global Agency Approvals |
|
|
|
|
The SlimModem2 measures only 1.0 x 2.5 x 0.2. This feature-rich modem module family is fully self-contained including built-in data pump, modem controller and on-board International DAA. This complete solution provides system engineers the flexibility to include modem functionality in system products with minimal engineering resources. Standard features of the modem include data rates from 300 bps up to 56 kbps, 14.4 kbps fax rate, voice playback and recording. The modem also provides enhanced features such as Caller ID, Extension Pick-up detect, Remote Hang-up, Quick Connect (V92SM2), DLG (Digital Line Guard) protection and 2nd Ring Detect. The 2nd Ring Detect feature allows complete power control from an incoming ring signal. It is ideal for remote application using battery power. Features:
-40°C to +85°C operating temperature Supports 3.3V to 5V operation Serial TTL Interface Enhanced AT Command set 300 bps up to 56 kbps data speeds downstream Upstream data rate up to 48 kbps (V92SM2) 14.4 kbps Fax Class 1 Voice playback and recording (TAM) -
DTMF tone detection and generation
V.44 data compression (V92SM2) V.42 bis and MNP 5 data compression Low power sleep mode option Line-in use and Extension pick-up detection Call waiting detection Distinctive ring and Caller ID Digital Line Guard (DLG) Protection 2nd Ring Detect Agency approvals:
Transferable FCC68, CS03 and CTR21 certified EN55022B, EN55024 c/UL60950 Recognized, EN60950-1, IEC60950-1 -
EN60601-1, IEC60601-1 (Medical Electronics)
CE Marking
Countries supported by existing firmware:
Australia, Austria, Belgium, Brazil, Canada, China, Denmark, Finland, France, Germany, Hong Kong, India, Ireland, Italy, Japan, Korea, Malaysia, Mexico, Netherlands, Norway, Poland, Portugal, Singapore, South Africa, Spain, Sweden, Switzerland, Taiwan, UK, US and TBR21 Generic. Order Information:
|
Product
|
Data Rates
|
Dielectric withstanding Voltage |
Fax/Voice
|
NVRAM
|
Speakerphone Ability
|
| 336SM2-RC |
33.6K bps |
1500VAC |
Yes |
No |
No |
| V92SM2-RC |
56K bps |
1500VAC |
Yes |
No |
No |
| V92SM2-RC-ADS2 |
56K bps |
3000VAC |
Yes |
No |
No |
| V92SM3-RCSP |
56K bps |
1500VAC |
Yes |
Yes |
Yes |
|
Ratings @ 25o C
Parameter |
Min |
Max |
Units |
| Tip / Ring Current Continuous |
10 |
120 |
mA |
| Dielectric Withstanding Voltage
(SM2-RC) |
|
1500 |
VRMS |
| Dielectric Withstanding Voltage
(V92SM2-RC-ADS2) |
|
3000 |
VRMS |
| Operating Temperature |
-40 |
+85 |
°C |
| Relative Humidity (non-condensing) |
10 |
95 |
% |
| Voltage Requirement |
3.15 |
5.25 |
VDC |
|
- Current Consumption
Regular:
3.3V |
70 |
83 |
mA |
|
- Low
Power
Mode Consumption:
3.3V
|
25 |
33 |
mA |
|
- Current Consumption
Regular:
5V |
70 |
83 |
mA |
|
- Low
Power
Mode Consumption:
5V
|
25 |
33 |
mA |
| Transmit & Receive Level |
-10
(Tx) |
-43
(Rx) |
dBm |
Mechanical Diagram & Pin Assignments - 
Note:
Pin 3 to pin 23 and pin 42 to pin 60 are not provided. Pin 25 is an open collector for the 2nd Ring Detect option Tolerance in mechanical dimension is +/-0.002" -
*DSR - Tied to GND through a 30-ohm resistor. Use to terminate DSR signal if necessary
-
Suggested mating female connectors:
|
Through Hole: |
|
a. Samtec P/N. #SQT-132-01-L-S (RoHS) |
|
|
|
SMT: |
|
a. Samtec P/N. #MMS-132-02-L-SV (RoHS) |
______________________________________________________________________________________________________ Information furnished by Radicom Research is believed to be accurate and reliable. However Radicom Research assumes no responsibility for its use, or any infringement of patents or other rights of third parties which may result from its use. Radicom Research reserves the right to change circuitry at any time without notice. This document is subject to change without notice. The information contained herein is subject to change without notice. Logos, trademarks and copyrights are property of their respective owners. |
^Back to top |
|
