V92MM4-TW - Leased-Line & Dial-Up Connections
|
|
|
|
|
Available: |
|
-40°C to +85°C Operating Temperature |
|
56K bps Data Rate |
|
Size: 2.16" (W) x 3.65" (D) x 0.375" (H) |
|
Asynchronous and Synchronous Data Format Support |
|
Fullplex Speakerphone |
|
|
|
|
These high-performance modem modules are fully self-contained with on-board data pumps and modem controllers. The modem features include -40°C to +85°C extended temperature operation, 2-wire leased-line or dial-up support and speakerphone functionality with microphone input. They operate under synchronous and asynchronous data formats and are built to meet most major country telecom requirements. Features:
Serial TTL interface V.92, 56 kbps data receiving 14.4 kbps fax, Group 3, Class 1 DTMF recognition and decoding -40°C to +85°C extended operating temperature Low profile, 2.16” (W) x 3.65” (D) x 0.375" (H) V.42, MNP 2-4 and 10-EC error correction V.42bis and MNP-5 data compression 2-wire leased-line and dial-up support Supports Synchronous and Asynchronous data formats Voice playback and record with microphone input Full-duplex speakerphone functionality Caller ID support, call waiting FCC68, CS-03 (Industrial Canada) and CTR21 (EU) certified.
Countries supported by existing firmware:
Australia, Austria, Belgium, Brazil, Canada, China, Denmark, Finland, France, Germany, Hong Kong, India, Ireland, Italy, Japan, Korea, Malaysia, Mexico, Netherlands, Norway, Poland, Portugal, Singapore, South Africa, Spain, Sweden, Switzerland, Taiwan, UK, US and TBR21 Generic. Note:
More country codes are available, please contact Radicom for information. More country Telecom Agencies such as Iceland, Luxembourg, Israel may adopt the TBR21 standards. The existing firmware could then be used to support those countries.
Ratings @ 25o C
Parameter |
Min |
Typ |
Max |
Units |
| Tip / Ring Current Continuous |
10 |
20 |
60 |
mA |
| Dielectric Withstanding Voltage |
|
|
1500 |
VRMS |
| Operating Temperature |
-40 |
|
+85 |
°C |
| Relative Humidity (non-condensing) |
10 |
|
95 |
% |
| Voltage Requirement:
5V system |
4.75 |
|
5.25 |
VDC |
|
- Power Consumption
- Normal |
|
155 |
|
mW |
|
- Low
Power
Sleep
Mode
|
|
26 |
|
mA |
| Transmit & Receive Level |
-10 |
-20 |
-43 |
dBm |
Mechanical Diagram & Pin Assignments - Serial Interface  Note:
Header extends on non-component side. Can be reversed if necessary (contact factory) -
Header length is 0.236" on non-component side
Pin spacing is 0.100" from center to center Tip and ring trace clearance must exceed 0.050" metal to metal -
0.350" H on component side (0.20" optional)
-
Suggested mating female connectors:
|
Through Hole: |
|
a. Samtec P/N. #SSW-110-01-G-D (RoHS) |
|
SMT: |
|
a. Samtec P/N. #SSW-110-22-G-D-VS (RoHS) |
_______________________________________________________________________________________________________ Information furnished by Radicom Research is believed to be accurate and reliable. However Radicom Research assumes no responsibility for its use, or any infringement of patents or other rights of third parties which may result from its use. Radicom Research reserves the right to change circuitry at any time without notice. This document is subject to change without notice. The information contained herein is subject to change without notice. Logos, trademarks and copyrights are property of their respective owners. |
^Back to top |
|
