336/560MM-PW, Worldwide Telecom Compliant, Parallel Interface Modular Modems™The 336/560MM-PW family is a self-contained module that provides system designers the flexibility to include modem functionality in any system product, with minimal engineering resources. The 336/560MM-PW family is built with on-board International DAA. Its firmware supports more than 30 major country's telecom requirements worldwide. The modem features 0oC to +70oC extended temperature operation, high-speed data rates up to 56 kbps, 2 wire leased-line support, optional ASVD and Caller ID. |
Features: - Parallel interface
- V.90, 56 kbps data (560MM-PW)
- V.34, 33.6 kbps data (336MM-PW)
- 14.4 kbps fax
- Voice playback and record
- DTMF decode
- 2 wire leased-line, auto negotiation
- 2.160" x 3.650" x 0.375"
- V.42, MNP 2-4 and 10-EC error correction
- V.42bis, and MNP-5 data compression
- FCC Part 68 registered
- Designed to meet UC/CSA and TUV requirements
- Worldwide telecom compliance *
- ASVD & Speakerphone (option)
- Caller ID (option)
| 
|
|
* This modem(s) is designed and built to meet worldwide telecom compliance. However, the modem could not be certified by itself. It must be certified in a finished product
Countries supported by existing firmware:
Argentina, Australia, Austria, Belgium, Brazil, Canada, China, Denmark, Finland, France, Germany, Greece, Iceland, India, Ireland, Italy, Japan, Korea, Luxembourg, Malaysia, Mexico, Netherlands, Norway, Philippine, Poland, Portugal, Russia, Saudi Arabia, Singapore, South Africa, Spain, Sweden, Switzerland, Taiwan, Thailand, UK, US and TBR21 Generic.
|
Ratings @ 25o C
| Parameter | Min | Max | Units | | Tip / Ring Current Continuous | 0 | 120 | mA | | Dielectric Withstanding Voltage | - | 1000 | VRMS | | Operating Temperature | 0 | +70 | oC | | Relative Humidity (non-condensing) | 10 | 95 | o/o | | Voltage Requirement | 4.75 | 5.25 | V | | Power Consumption | 720 | 880 | mW | | Transmit & Receive Level | -10 (Tx) | -43 (Rx) | dBm |
| Mechanical Diagram & Pin Assignments - Parallel Interface 
| Note: - Header extends on non-component side. Can be reversed if necessary. (contact factory)
- Header length is 0.236" on non-component side.
- Pin spacing is 0.100" from center to center.
- Tip and ring clearance must exceed 0.100" metal to metal.
|
Information furnished by Radicom Research is believed to be accurate and reliable. However Radicom Research assumes no responsibility for its use, or any infringement of patents or other rights of third parties which may result from its use. Radicom Research reserves the right to change circuitry at any time without notice. This document is subject to change without notice.
The information contained herein is subject to change without notice. Logos, trademarks and copyrights are property of their respective owners.
(560mmp.DOC) |
