336/560MM-TW-Aii, Serial Interface Modular Modems
These V.90, 56 kbps high performance modem modules are fully self-contained with on-board data pumps and modem controllers. The modem features - 40oC to +85oC extended temperature operation, 2 wire leased-line and dial-up support. They are operational under synchronous and asynchronous data formats. The modems are built to meet more than 30 major country telecom requirements. Features:
Serial TTL interface V.90, 56 kbps data receiving (560MM-TW-Aii) V.34, 33.6 kbps data sending and receiving 14.4 kbps fax, Group 3, Class I and II Voice playback and record DTMF decode -40oC to +85oC extended operating temperature Low profile, 2.16" x 3.65" x 0.20" (H) V.42, MNP 2-4 and 10 error correction V.42bis, and MNP-5 data compression 2-wire leased-line and dial-up support Synchronous and Asynchronous data formats support Designed to meet global telecom compliance
Agency Approvals:
FCC68 & CS-03 approved CTR21 Compliant
Countries supported by the existing firmware:
Argentina, Australia, Austria, Belgium, Brazil, Canada, China, Denmark, Finland, France, Germany, Greece, Hong Kong, Iceland, India, Ireland, Italy, Japan, Korea, Malaysia, Mexico, Netherlands, Norway, Philippine, Poland, Portugal, Russia, Saudi Arabia, Singapore, South Africa, Spain, Sweden, Switzerland, Taiwan, Thailand, UK, US and TBR21 Generic.
Ratings @ 25o C
| Parameter |
Min |
Max |
Units |
Tip / Ring Current Continuous |
0 |
120 |
mA |
Dielectric Withstanding Voltage |
- |
1650 |
VRMS |
Operating Temperature |
-40 |
+85 |
oC |
Relative Humidity (non-condensing) |
10 |
95 |
o/o |
Voltage Requirement |
4.75 |
5.25 |
V |
Power Consumption |
720 |
880 |
mW |
Transmit & Receive Level |
-10 (Tx) |
-43 (Rx) |
dBm |
Mechanical Diagram & Pin Assignments - Serial Interface 
Note:
Header extends on non-component side. Can be reversed if necessary. (contact factory) Header length is 0.236" on non-component side. Pin spacing is 0.100" from center to center. Tip and ring trace clearance must exceed 0.100" metal to metal.
____________________________ Information furnished by Radicom Research is believed to be accurate and reliable. However Radicom Research assumes no responsibility for its use, or any infringement of patents or other rights of third parties which may result from its use. Radicom Research reserves the right to change circuitry at any time without notice. This document is subject to change without notice. The information contained herein is subject to change without notice. Logos, trademarks and copyrights are property of their respective owners. ^Back to top |
|
